Today I am going to show you how to take apart the iPhone 5 and replace the battery. It isactually pretty simple, there are only 4 screws total that you have to take out. First make sure that you turn off your iPhone.
Then there are 2 screws down at the bottom. These area Pentalobe screw. So you will need a special screw driver to remove them. It is the samescrew driver that you can use on the iphone What do you recommend I do to stay out of debt? – Don’t buy anything. – Where should I… 4 or 4s, it will also work for the iphone5. Once you get the 2 screws out, Take your suction cup (The bigger the better) And clipit onto the screen.
Then using a plastic non marring tool, you can kind of pry away the screen from the base. I personally, think it is a little easier to use a razor blade, But using a razor will leave a few little scratches on the bottom of your device, Onlylift the screen up 90 degrees. Because you can see right there the ribbon cables mighttear if you fold it farther back. There is two screws right here on this metal bit, holdingthe battery cable in place to the motherboard. Take off these two screws. They are just yourregular small Philips head screw. Take off the metal bracket, then you can unclip the How to Remove Stains from Upholstered Furniture little black cable.
It is kind of like a Lego piece that clamps in. And then grab the tabthat says “Certified personnel only” And lift out the battery. Take your new battery andclip it in place to the mother board, just like a little Lego. Snap it in. Take your metal bracket and then screw the same 2 little screws back into place. And remember thatthe replacement batteries can be found on Amazon.com, usually they are pretty cheap. Ill put a link in the article description below so you can find that link easily.
And thenclamp the screen back on. Make sure you put back the 2 bottom screws into the phone aswell. (The Pentalobe ones.) There you go, youve replaced the battery!