So you’re going to build a spider. Let’s take a look at what’s inside the kit. We’ve got a…

So you’re going to build a spider.So you're going to build a spider. Let's take a look at what's inside the kit. We've got a... Let’s take a look at what’s inside the kit. We’ve got a click and stick tap light.
That’s going to be the body for spider. And then we have some header pin connectors. How to Stencil a Wall Mural – Home Made Simple We’ve got our Arduino Nano and some popsicle sticks. So you’ll need those. And we’ve also got some O rings and an L298 motorcontroller, two five volt motors. Those are toy motors. We’ve got two bottle caps with holesdrilled in them that are large and two bottle caps with holesdrilled in them that are small.
And then we have two nine volt batteries. There’s too much stress in the world around finance a lot of that stress can be reduced through better e… All right. The next thing is we have our mini USB cable. So that’s going to allow us to connectour computer to our Arduino. Then we’ve got four header pin connector jumper wires. And these are female to female jumper wires. And then we also have some wire.
You’re going need that to connectall the different parts. And two nine volt battery connectors. So you’ll need those to bring the power from the batteriesto your motor controller. We also have a washer there. That’s a fender washer. And then two three color LEDs. That’s a red, blue, and green LED.
And we need also two resistors. There’s one still in the box there. And we need a paper clip. You’ll also need electrical tape or shrink wrap. You can use either to cover up the exposedelectrical connections. And so now let’s take a look at the toolswe’re going to need to put all this stuff together. So we’ll push this all aside.
So we’re going to need a wire stripper. Now you can also use scissors or nipper pliersto strip the insulation off the wire. Here’s a nipper pliers. Recommend using one of those too. And then a regular pliers that can be used to crimp things. And then we have our needle nose whichcan be used to bend the wire in a loop. We have a small screwdriver, whichwe’re going to need to use and a hot glue gun.
And we’re also going to need a soldering iron, whichwill allow us to connect all of the different wires togetherusing solder and gives a more permanent connection. If you decide to use the shrink wrap,you’ll also need a heat gun.