Hi, I’m Mark.
In this article, I’m going to show you howto replace the brushes in a Makita grinder. The brushes rub against the commutator on your grinder’s armature. They’re responsible for transferring electricityto the spinning armature. They’re made of carbon, and because of that,they will wear down with normal use. And eventually, you’ll need to replace them. 12 Closet Organization Ideas You’ll Want to Steal Immediately to make the most of your space Replacing the brushes is easy to do, and I’m going to show you how. Carbon brushes, as well as many other parts, can be found on our website.
Let’s get started. I’ll begin by removing the side handle and the guard. Now I can remove the rear housing. It’s held in place with a single screw. Now I’ll pull the brush spring away fromthe brush. Just pull it off to the side and let it sit. Now I can remove the brush.
I’ll pull the connection away with a pair of pliers. Andpull the brush from the brush holder. Now I can install the new brush. I’ll slide it into the holder. And reattach the wire to the brush holder. Hi I am Drew Fendy, master home inspector. I have been inspecting for over 24 years.
Today we are going t… And I’ll replace the brush spring back on top of the brush. Now I’ll repeat this process on the other side. Now I’ll make sure the wires are tucked out of the way, and reinstall the rear cover. And I’ll finish up by installing the guard. And the side handle. And that’s how easy it is to replace the carbon brushes on a Makita grinder.