bundys garage bundy here hey today we are looking at 3 motor mounts off the same vehicle t…

bundys garage bundy herehey today we are looking at 3 motor mountsbundys garage bundy here hey today we are looking at 3 motor mounts off the same vehicle t... off the same vehicle these came off a hondaodysseythis is the rear motor mount this is the side Crafts For Kids To Make By Marissa Volibear mount on the passengers side and this is abrand new side motor mount on the passengersside the reason i’m showing you these three motor mounts is the fact that i didn’t feellike spending $47.00 usd dollars what$52 dollars after tax on a passenger sidemotor mount so what i did and you guys can dothis too it also helps you can either save amotor mount that’s damaged or weak or you Hi! This is Jon on behalf of Expert Village.
In this article clip I will be talking about electrical safe… could take a brand new motor mount and ita little bit more robust if that’s the rightword to use so right here you can see this is the original side motor mount thatcame off the vehicle it was actually crackedand broken inside there was oil in the mountand it started spilling out and i took it off andchecked it out a lot of the rubber had brokenoff and cracked inside of thereyou can go to home depot they sell this stuffat lowe’s as well it’s made by loctite it’scalled roof and flashing polyurethanesealant chinninies joints and shinglespl pro line loctite roofing and flashingpolyurethane comes out black and it dried likea hard rubberas you can see right therei’ve actually already put the polyurethanein the motor mount surrounding theeyelet where the bolt goes throughon the back side here i just took duct tapewrapped the back of it so none of thepolyurethane would slip out on the backsideit’s still drying so i’m trying not to touch itand i have it up here on this thermostatso it dries correctlyif you take a look at the new motor mounttake this off real quickthis is a thin little layer right hereyou could actually pop your inger rightthrough there it goes to the other sidebut you can see there’s not a whole lot ofmaterial in this so if you wanted to stiffenthis up a little bit make it more robustjust seal this off with ducttape one sidedoes not really matter whichand just start filling it up with theloctite polyurethaneso you could do this to a new motor mountyou could do it to one that’s damagedi’m showing you this one over here this is therear motor mount off the honda odysseythis is beyond repair so you can’t fix this oneactually did this to the motor mountthat new motor mount that went into the vanso i’ll put a link in the description belowof when i did this but like i said if you guyswant stiffen up a new motor mountor if you want to save an existing motor mountlike i’ve done herego ahead pick up some loctite plpolyurethane roofing and flashingi’ll put a link in the description belowgetting polyurethane everywherejust a quick tip from bundys garageif your motor mountsneed to be more stiff a little bit morerobust or save a motor mount that’salready damaged