Alright today I’m going to show you how to replace the battery in the iPhone 6S. There are two w…

Alright today I’m going to show you how to replace the battery in the iPhone 6S. Thereare two ways to replace the battery there is an easy way and there’s a hard way.
IAlright today I’m going to show you how to replace the battery in the iPhone 6S. There are two w... will be showing you both ways. The actual battery replacement will be starting at the1:15 mark. I will link tools and replacement batteries down in the article description. Socheck those out if you need them. To get at the battery you do have to open up the phone. DIY Valentine’s Day Gift Ideas With your pentalobe screw driver you can remove the bottom 2 screws from the phone.
Then youcan lift up on the screen with a suction cup and slide a tool between the metal frame ofthe screen and the metal frame of the phone. Pry it very gently. There is adhesive surrounding the screen and the frame. So I’m going to go ahead and slide my plastic pry tool betweenthe two and separate them. That makes it easier to lift off the screen from the frame. Prettystraight forward. There are 4 screws holding down this metal plate.
I remove those 4 screws,lift off the metal plate, and then disconnect each of these little ribbon cables. You defiantlydon’t want to let the screen bend past 90degrees or it will damage the cables. Once Welcome to the Smart House online simulation walkthrough. These are sample users with pre-defined prefere… the screen is removed you can see the little battery down here, and the little connectionfor it. So just unscrew those two screws, and remove the metal plate. So here is thewrong way to remove the battery. There are these two little pull tabs down here at the bottom.
You can see that I am unsticking it from the battery right now. They are kindof hard to grab because they shrink up as soon as you remove them. Here is where I wentwrong. I took the pull tab, once I got ahold of it, and pulled it through the side of thephone. Which make the pull tab break, and makes it a harder repair. If you actuallyjust take to pull tab and pull straight out the bottom, and not around the battery likeI am doing right now. Just pull straight out the bottom, and you can see it pull out entirelyaway from the battery.
So easy. Now that’s one whole half of the battery that I don’thave to unstick from the back. But since I messed up on the first time around with thefirst pull tab I have to do the pry of shame to pull the battery out from the back of thehousing. The sticky tap is pretty strong stuff. The best way to do it is just pull the littletab out from the bottom of the battery and yank it right out. To put the battery backin place you can buy new pull tabs or you can just use take double-sided tape. Thenstick it down underneath the battery so that it doesn’t jiggle around inside of the housing.
Take the battery and plug it back into place. Take the two screws and screw them into themetal plate over the connection. Then you can take the screen and plug in the connectors. You have the one for the front facing camera, you have the LCD, and you have the digitizer. Once they are plugged into place they are like little Legos. You just kind of plug themin. Before putting the metal plate down.
I am going to test to see if the screen is working. If you have lines or a white screen there is a good chance that one of your connectionsisn’t quite right so disconnect connect it and re-plug in the ribbing cable. Thento line up the screen I usually take it and push it into the top of the housing first. Then I can slide my hands down the side of the screen to lock it into place. Get thetwo screws in at the bottom, and you are good to go.